TSS HUR-120 BT - přepínání režimů chování

KB0262

To switch RFID sensor modes, you need

1) Slide the switch in the slot below the MicroUSB connector to OFF

2) Turn the slide switch to ON

3) Hold the scan button until the sensor beeps (about 15 seconds)

4) The LED on the sensor will flash according to the active mode

- Red Power = SPP profile (the only one that allows MultiTag)

- Orange Power = HID profile (sends EPC in HEX form without ENTER at the end)

- Green Power = HID profile (sends EPC in HEX form with ENTER at the end)

- blue Status = HID profile (sends EPC in ASCII form without ENTER at the end, replaces illegible characters with a period)

- white Status = HID profile (sends EPC in ASCII form with ENTER at the end, replaces illegible characters with a period)

5) It is possible to switch between the modes by short pressing the scan button

6) To confirm the selected mode, leave the sensor on for about 15 seconds. Then it beeps and switches off.

7) Switch on the sensor by pressing the scan button (approx. 3-4 seconds)

8) The sensor will appear in the BT device list (mobile, NTB, ...) as HUR120BT_<serial number>

NOTE: If the sensor is in HID mode and the user presses the scan button, the Status LED will light up orange during the search period. If there are multiple tags within range of the sensor, none will be returned!

-MP-