CipherLab 1862 - instalace a nastavení

KB0018

Starting CipherLab 1862 with EZ config 1.3.1.

1) You need to install 1800EZSuit_v1.3.1

2) In the program installation you need to check the Cipherlab VCOM CDC driver installation (Recommended)

3) After installing the program and the driver, the reader should be switched on and connected to the PC.

4) After creating the driver, you need to check via Windows Device Manager which COM port it is on.

5) You need to set the desired serial port in 1800EZSuite (Start - Cipherlab - 1800EZSuite - USB service configuration)

6) In the USB service configuration you need to tick the Cipherlab USB virtual COM CDC driver

7) Then you need to enter the number of the created COM port and give OK

8) You can start the 1800 EzSuite program - the reader will connect to the program via USB immediately.

ATTENTION!!! if the COM port is not set, the 1800EZSuit program will not connect to the RFID reader and you will not be able to set the required parameters.

-JB-