CipherLab 1562, 1564 - BT SPP virtuální sériový port přes bluetoothKB0022
Postup pro nastavení BT SPP (virtuální sériový port přes bluetooth) u čteček CipherLab 1562 a 1564
To be sure, reset the CipherLab 1562 /1564 to factory settings (keep the base disconnected) by removing these codes
BT SPP and PIN settings
(PIN digits do not need to be set any further - the default is automatically 0000)
Then locate the new bluetooth device and make the connection to 1564BH.....
Enter PIN 0000. Do not connect yet, but install the virtual serial port dongle drivers of the bluetooth adapter. Two serial ports (outgoing and incoming) will be created. Connect the Hyperterminal to the incoming port for a test and connect the reader. The codes can then be read. The application will reconnect itself by connecting the serial port.
-PB-
Applies to:
- 1560P Kit USB: Wireless Linear Imager + Cradle + USB Cable, Bluetooth (A1560PSET-U)
- 1560P Wireless CCD scanner (only scanner with battery) (A1560P-SCAN)
- 1560P Bluetooth Linear Imager + Cradle + RS232 Cable, Bluetooth (A1560PSET-R)
- 1560P Kit USB: Wireless Linear Imager + Cradle + USB Cable, worn, used one, Bluetooth (A1560PSET-UP)
- 1562 Wireless laser scanner (only scanner with battery), Bluetooth (CipherLab) (A1562-SCAN)
- 1562 Laser Scanner + Cradle + RS232 Cable, Bluetooth (A1562SET-R)
- 1562 Wireless Laser scanner + Cradle + USB Cable, Bluetooth (A1562SET-U)
- 1564A Wireless 2D-code scanner + Cradle + RS232 Cable, Bluetooth (A1564ASET-R)
- 1564A Bluetooth, Wireless 2D Code Reader (scanner only) (A1564A-SCAN)
- 1564A Wireless 2D-code scanner + Cradle + USB Cable, Bluetooth (A1564ASET-U)
